jesper32 Posted January 22, 2016 Share Posted January 22, 2016 Hi guys I just got myself a pair of Yamaha heated grips: Yamaha Grip Heater 120 YME-F2960-00-00 Been fitting these according to the instructions, and checked for lose, cramped or otherwise damaged wires, but everything looks good. My issue is, that they are not working and no LED's are being turned on. It does get VERY hot behind the control panel, but no where else. Any suggestions as to what could be the issue or could they be faulty? Br Jesper Link to comment Share on other sites More sharing options...
caliesv Posted January 23, 2016 Share Posted January 23, 2016 Sounds simple, but did you make sure your polarity was correct for 12vdc? Link to comment Share on other sites More sharing options...
jesper32 Posted January 23, 2016 Author Share Posted January 23, 2016 Sounds simple, but did you make sure your polarity was correct for 12vdc? I'm sure I did. Black to black and red to red Link to comment Share on other sites More sharing options...
caliesv Posted January 23, 2016 Share Posted January 23, 2016 Maybe try and connect them straight to a 12vdc source and see if they work. If not, then you might need a new set. Link to comment Share on other sites More sharing options...
ducttapewd40 Posted January 24, 2016 Share Posted January 24, 2016 I'm going to guess you got a defective unit with a short in there somewhere. Is it pretty plug and play, or do you need to do much wiring yourself? Link to comment Share on other sites More sharing options...
cndnmax Posted January 24, 2016 Share Posted January 24, 2016 The controller should not get hot, only the heating elements. Check for voltage at the plug for the slave grip and to the controller. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.