Premium Member fzar Posted October 3, 2018 Premium Member Share Posted October 3, 2018 5 hours ago, DewMan said: Would replacing the OEM nut with an aftermarket Gilles titanium nut be enough to minimze the likelihood of galling? I'm going to find out when I get my parts from the dealership!! Link to comment Share on other sites More sharing options...
shinyribs Posted October 3, 2018 Share Posted October 3, 2018 5 hours ago, DewMan said: Replacing the axle nut every time I adjust my chain seems unreasonable. The shop manual does not suggest replacing the axle nut when doing tire replacements nor chain adjustment. Yeah, this is a waste of money and resources. In no way are these disposable parts. They are standard fittings, not yield to torque fasteners. A drop of lube and they will last literally forever. These aren't cheap nuts Yamaha gave us. They're actually expensive since they are the best mass production locking design nut money can buy. Link to comment Share on other sites More sharing options...
firstyammerha Posted October 3, 2018 Share Posted October 3, 2018 looking at Fzar's picture of 5:53 sunday showing the adjustment block projecting from the swingarm, doesn't the axle go through the adjustment block? Link to comment Share on other sites More sharing options...
rick Posted October 4, 2018 Share Posted October 4, 2018 16 hours ago, firstyammerha said: looking at Fzar's picture of 5:53 sunday showing the adjustment block projecting from the swingarm, doesn't the axle go through the adjustment block? Nope. That end piece just sits there and pushes against the back of the swinger. The "bolt" that projects out the back is attached to a piece inside that the axle goes thru. Pull the bolt backward by threaded the adjuster nut in and the axle is pulled backward. Link to comment Share on other sites More sharing options...
firstyammerha Posted October 4, 2018 Share Posted October 4, 2018 Thanks Rick. The last bike that I removed the rear wheel from was a 1978 Suzuki GS1000E and that was about 5 years ago. Link to comment Share on other sites More sharing options...
rick Posted October 4, 2018 Share Posted October 4, 2018 Have a buddy who had a 79 GS1000 and then an 82 GS1100 - man, that thing was fast back then. This will make it pretty clear. The working bits you asked about are # 22 and 23/24. As solid looking as the swing arm appears, it's closer in thickness to a tin can than anything massive. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.