topazsparrow Posted August 15, 2017 Share Posted August 15, 2017 Is it normal for there to be a bit of grease around the bottom of the steering head bearing? I'm under the impression they are supposed to be sealed and not make a mess like this? I'll try and snag a picture later tonight, it's not a lot but it's enough that if I run my finger along the rim on the bottom I'd come back with a gooey finger. Link to comment Share on other sites More sharing options...
mossrider Posted August 15, 2017 Share Posted August 15, 2017 Normal. Not sealed. And be careful where you stick your finger. Link to comment Share on other sites More sharing options...
r1limited Posted August 15, 2017 Share Posted August 15, 2017 Normal. Not sealed. And be careful where you stick your finger. He could get some on his finger then wipe it on the wall How hot has it been there lately, possble that natural heat may have caused some of the factory snot they call grease to ooz a tad. “Laws that forbid the carrying of arms disarm only those who are neither inclined nor determined to commit crimes.” --Thomas Jefferson quoting Cesare Beccaria Link to comment Share on other sites More sharing options...
YZEtc Posted August 15, 2017 Share Posted August 15, 2017 It's sealed with a rubber seal (otherwise dirt and moisture would contaminate the bearing), but it's not unusual to see a new bike on a showroom with a bit of grease there left over from assembly at the factory. Link to comment Share on other sites More sharing options...
rick Posted August 18, 2017 Share Posted August 18, 2017 And be careful where you stick your finger. always good advice Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.