Jump to content
The MT-07 Forum

Questions about installing shogun frame sliders


mrfat17

Recommended Posts

Hi all,
I have shogun frame sliders that i am about to install. Do I need a rear tire stand to do this? Or does the kickstand + spotter provide enough support?
 
thanks,
 
mrfat17

Link to comment
Share on other sites

ducttapewd40
Hi all, I have shogun frame sliders that i am about to install. Do I need a rear tire stand to do this? Or does the kickstand + spotter provide enough support?
 
thanks,
 
mrfat17
 
 
Probably don't even need the spotter
Link to comment
Share on other sites


 
This video shows what you're trying to do. Only things I would do different are use a breaker bar to loosen and make sure to use a torque wrench when tightening. You don't need a rear stand or a spotter - especially if you have a breaker bar.
Link to comment
Share on other sites

  • 2 months later...

I did my Woodcrafts with just the kickstand.

 

Just use a breaker bar and apply leverage at the correct angle, brace the joint on the breaker bar with your other hand, and you should be fine. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.