suspiciouspackage Posted May 29, 2015 Share Posted May 29, 2015 My Cyclops H4 LED bulb came in today and I finally got to put it in. Went out for a ride that would take me back home at dark and when I started it up, I noticed that it has that notch that the original bulb fooschnickens reviewed had. Now maybe I just didn't adjust it properly (I'm hoping) or worse case, it's actually defective. Can someone chime in? Low Beam High Beam [span style=max-width:100%][/span] And if anything, tell me if I have the beam pointed too low or high. I'm never a good judge myself. Link to comment Share on other sites More sharing options...
cndnmax Posted May 29, 2015 Share Posted May 29, 2015 Looks like it's working fine to me. There's a left/right side to the bulb. Just make sure u didn't put it upside down and that one led from both sides light up for low and all 4 less for high. As far as the aiming goes, follow the DIY posted. Link to comment Share on other sites More sharing options...
bmwpowere36m3 Posted May 29, 2015 Share Posted May 29, 2015 fooschnickens, who originally reviewed the cyclops bulb noted the same notch in the beam pattern. Judging by the high beam, I'd say both are a little low. Best way to check is against a flat wall 20-30' away and setting the low beam cutoff about a inch or do below the height of the bulb. Then go ride and check the pattern. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.